Please follow these suggestions:
1.
Close doors to areas you do not wish to heat.
2.
Locate an outlet along an interior wall if possible. Position the heater so that the warm air can blow
unobstructed across the room towards the exterior walls.
3.
Check your windows and doors for the infiltration of cold air and insulate as needed to avoid heat loss.
Rapid heat loss will minimize the effectiveness of your heater as it would any conventional type heater.
4.
Keep the area around the heater free of obstructions to insure maximum airflow. Keep electrical
cords, drapery, furniture, and other combustibles 3 feet (0.9 M) away from the front of the heater
and away from the sides.
5.
Avoid locating your heater in high traffic areas or in direct sunlight.
6.
Avoid locating your heater near your central heating thermostat.
INSTRUCTIONS FOR POWER
WARNING: Before servicing this heater be sure to unplug heater from wall outlet.
Do not only turn off heater from the main “ON/OFF” switch, be sure to unplug this
heater.
.
ELECTRICAL
CONNECTION
AC120Volt, 60Hz circuit with a properly
grounded outlet is required. Preferably, the
heater will be on a dedicated circuit. Other
appliances on the same circuit may cause the
circuit breaker to trip or the fuse to blow
when the heater is in operation. The unit
comes standard with a two wire cord exiting
from the rear of the appliance.
WARNING:
Electrical
outlet wiring must comply with
local building codes and all
other applicable regulations to
reduce the risk of fire, electrical
shock and injury.
WARNING:
Do not use this
appliance if any part of it has
been under water. Immediately
call a qualified service
technician to inspect the
appliance and replace any part of
the electrical system if necessary.
~ 4 ~
