6.1.3
Monitor Calibration
Various sources, including JS, recommend monitor calibration before scanning, and report that the
most usual reason for “unsatisfactory” scans is that the monitor on which they are being viewed is
not correctly calibrated – the same pictures can appear greatly improved, just by viewing on a
different monitor.
The most reliable method of monitor calibration is by hardware and software. The software
displays a test picture of multiple colours, a hardware sensor is then moved across the screen and
measurements of different colours are taken. The software then compares the sensor readings
against a defined norm and creates a profile to compensate for any differences. Such a process is
essential for a professional scanning service, but the kit is rather expensive for the amateur
photographer. I am taking my chances (the pictures look fine on 2 monitors at home and one in my
office), and so is Martin.
6.1.4
Scanner Calibration
The scanner performs a self-calibration before each scanning session, and at various times during
the session – the message below is displayed. This nothing to do with the IT8 calibration, which is
performed by scanning a special slide delivered with Silverfast.
6.1.5
Noise During Scanner Operation
The scanner makes various noises during operation and also vibrates a certain amount. JS
recommends that instead of placing it directly onto a desk, there should be some absorbent
material underneath, e.g. a piece of carpet.
Cyberview
Page 17 of 33
Dec 2008
