CHANGING THE SPONGE BELT
1.
Ensure engine is turned off
2.
Remove water container (see previous instructions)
3.
Hang out pressure grouted springs
H
on both sides and take off the pressure roller
D
4.
Open knob
X
and remove the sponge belt at the right side
5.
Replace sponge belt. Make sure tape direction is correct
6.
Put the V-belt in the notches
7.
Close knob
X
8.
Put the pressure roller
D
from the right side into the machine and inside the sponge belt and adjust
it with the pressure-grouted springs
H
9.
Add the water bucket
10.
Loosen pressure roller
D
from the holder
11.
Press down pressure
D
and slew the pressure roller with the clamping pin
E
into the centre so you
can tighten part
D