2
WARNING!
Do not exceed the lesser of the maximum load capacity of 800 lbs. (evenly distributed) or the vehicle manufacturer’s specified load
capacity for rail mounted accessories. “Distributed load” is defined as a load that is not concentrated in a small area.
Any load carried above the bed rails will increase your truck’s center of gravity and will significantly hinder your trucks ability to
maneuver, stop turn or accelerate. Avoid sharp turns and excessive speeds as this will increase risks.
This truck rack is solely intended for, and only safe for, transporting ladders, lumber, pipe and other similar materials or recreational
items such as canoes and kayaks.
Ladder damage will occur from road shock and vehicle vibration if the ladder is not properly secured to the rack. The bouncing side to
side motion of an improperly secured ladder will cause wear and weaken the ladder. Using a damaged ladder could lead to a structural
collapse and could result in a serious injury or death.
Any modification or unintended use of this product voids any warranty and could create a hazardous condition that may result in
property damage, serious bodily injury and/or death. The sole exception being permanent mounting within the prescribed method.
Always secure long loads to front and rear of vehicle for safe transport.
Do not use in truck beds that have excessive rust as it may decrease the capacity and result in product and/or bed failure.
Truck beds with liners may require modification prior to use of the product.
The installation and use of any rail mounted accessory may cause minor aesthetic damage to the vehicle exterior. Cequent Consumer
Products makes no claims or warrantees whatsoever as to a particular vehicle’s ability to support rail mounted accessories without
incurring damage.
IMPORTANT!
Loads that exceed the vehicle manufacturer cargo and / or entire gross vehicle weight (GVW) rating, are not covered by this warranty.
Consult and follow your vehicle manual for capacity ratings.
Always evenly distribute load on rack before driving.
Loads must be secure according to local height and identification regulations and or laws.
Secured loads and connections must be re-checked periodically for tightness.
Overloading the vehicles GVW may cause damage and severely alter the vehicle’s handling and braking characteristics and or cause the
vehicle to roll over.
It is recommended the tailgate be in the up position during use to better stabilize the truck bed.
Always obey posted speed limits and traffic cautions.
Lubricate with an anti-seize lubricant for best long term performance of stainless steel hardware.
Failure to follow these warnings or instructions will void the warranty.
Some vehicle manufacturers require a reinforcing kit. Contact your dealership for details.
Fit Up
The TransRACK was designed to be installed on trucks without a traditional over the rail plastic bed liner. Installation is possible on truck
with under-the-rail bed liners with minimal trimming. Spray on bed liners will not interfere with this product.
The TransRACK is based on vehicle design available at the revision of these instructions. The TransRACK is designed to fit a variety of bed
lengths and cab designs. It is not recommended for the following vehicles: Toyota Tacoma.
Required Tools
9/16” Socket 9/16” Wrench 1/8” Hex Key
