12
b) Installing the Receiver
Installation of the receiver depends on the model. For this reason, you should always follow the recommendations of
the model manufacturer regarding the installation.
Regardless of the model, you should always try to install the receiver so that it is protected from dust, dirt, moisture,
heat and vibration in the best possible way and is not located in the direct proximity of the rechargeable battery/motor
lines.
Keep enough distance from motors and electronic flight or speed controllers. Metal or carbon parts have a shielding
effect and thus may considerably impair reception. In this case, it is mandatory to relocate the aerial outwards through
a bore in the fuselage.
Two-sided adhesive foam (servo tape) or rubber rings that hold the foam-wrapped receiver securely in place are
suitable for fastening.
Attention!
The aerial wire (1) length is determined precise-
ly.
For this reason, you must not roll up the wire,
place it in a loop or cut it off. This would de-
crease the range significantly and thus pose a
considerable safety risk.
Figure 6
Содержание HT-5
