11
Set Time
1. Press the
SETUP
button to enter the set up mode.
2. Press the and arrows to highlight the icon.
3. Press the
button to enter the "Time Setup" screen.
4. Press the and arrows to adjust the Hour digit which is the first
flashing value.
5. Press the
button to proceed to the next value.
6. Repeat steps 4 and 5 to set the "min" and "sec" values.
7.
Press the
ESC
button to exit the setup menu and resume normal operation.
Setting Alarm Threshold
An alarm will sound when the measured value is greater than the Alarm
Threshold. The default alarm is set at 205μSv/h. Follow the steps below to
set the alarm threshold.
1. Press the
SETUP
button to enter the set up mode.
2. Press the and arrows to highlight the "ALM" icon.
3. Press the
button to the "Alarm Threshold Setup" screen.
4. Make sure to start with the leftmost digit.
5. To toggle between digits press the enter button to move to the next
digit or press the
ESC
button to return to the previous digit.
6. When ready, press the and arrows to adjust the flashing digit.
7. Press the
button to confirm your selection and proceed to the
next digit.
8. When the last digit has been selected and confirmed, press the
ESC
button to exit the setup menu and resume normal operation.
Enabling/Disabling Pulse Sound
When radiation is detected the meter will make a "ticking" sound. The
stronger the radiation signal the faster the "ticking" sound will be. Follow
the steps below to enable/disable the pulse sound.
1. Press the
SETUP
button to enter the set up mode.
2. Press the and arrows to highlight " ".
3. Press the
button to enter the pulse sound setup screen.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
