15
Verify Set Time and Date
During normal operation press the
TiME CHECK button to display the
year, month, day, hour and minutes.
Verify Sampling Rate
During normal operation, press the SAMPLiNG CHECK button to view the
selected sampling rate.
Data Logging
Data Recording Modes
Manual Data Logging:
Press the
LOG
button to manually log up to 99
readings on a SD memory card (see
Manual Data Logging Mode
for details).
Automatic Data Logging:
Setup the meter parameters in order to
automatically log data on a SD memory card. The number of data points
is limited by the size of the memory card.
Note:
it is recommended to use a class 4 SDHC memory card between 1Gb
and 16Gb. insert the SD memory card in the slot at the bottom of the meter.
The card must be inserted with the label side facing the rear of the meter.
Manual Data Logging Mode
In manual mode, the
LOG
button is pressed to manually log a reading on
the inserted SD card at any time. In order to setup the meter for manual
data logging, follow steps 1 through 8 below.
1. Set the data logging sampling rate to "0" seconds (see
Setting the
Data Logging Sampling Rate
section for details).
2. Press the
REC
button and "REC" will appear on the LCD.
3. The meter will also display P-X (X = memory position number
between 1 and 99).
4. Press the
SET
button to enter the data memory positions selection.
5. Press the and buttons to select one of the 99 data memory
positions in which to record.
6. Press the
ENTER
button to confirm selection.
7. Press the
LOG
button to save a reading to memory. "REC" will flash
each time a data point is stored.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
