13
Setting Data Decimal Format (dEC)
Numeric formats vary in different countries. By default the meter is set
to bASIC mode where a decimal point is used to separate units, (i.e.
20.00). The European format uses a comma (i.e. 20,00) to separate units.
To change this setting, follow steps 1 and 2 when the "dEC" parameter
appears on the LCD.
1. Press the and buttons to select between bASIC and Euro.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Enabling/Disabling Auto Power Off (PoFF)
Follow steps 1 and 2 when "PoFF" appears on the LCD.
1. Press the and buttons to select between ON (enabled) or OFF
(disabled). With the Auto Power OFF feature enabled, the meter will
automatically switch OFF after 10 minutes of inactivity to preserve
battery life.
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
Enabling/Disabling the Beeper (bEEP)
Follow steps 1 and 2 when "bEEP" appears on the LCD.
1.
Press the and buttons to select between ON (enabled) or
OFF (disabled).
2. Press the
ENTER
button to confirm selection and skip to
next parameter.
Note
: At any time, you can press the
ESC
button to exit the Setup mode
and resume normal operation.
continued...
REED Instruments
1-877-849-2127 | [email protected] | www.reedinstruments.com
