7
4. Refer to the inset drawing. Detach the Extension Wire
(15) from the Resistance Cable (17). Plug the
Extension Wire into the back of the Console (13).
Next, route the Resistance Cable (17) on top of the
Upright (2) so that it will fit beneath the Console (13).
Make sure that the Resistance Cable is not kinked
and that it does not block the indicated hole.
Place the Console (13) on top of the Upright (2).
Attach the Console with six Console Screws (33).
Press the Pedal Resistance Knob (16) firmly onto the
Resistance Control (17).
5. Locate the Left Handlebar (10); there is an “L” decal
on the Left Handlebar for identification. Slide the Left
Handlebar onto the pivot rod on the left side of the
Upright (2). Make sure that the Left Handlebar is
turned so the recessed Inner Handlebar Bushing (18)
if facing the Upright. Tap an Axle Cap (41) onto the
end of the pivot rod.
Repeat this step to attach the Right Handlebar (11)
(not shown).
5
10
Pivot
Rod
41
2
18
11
33
16
17
13
2
33
6. Attach a Pedal (9) to the Left Pedal Arm (7) with three
M4 x 16mm Screws (51).
If there is not a Wheel (60) on the Left Pedal Arm (7),
attach one in the following way: Hold a Wheel (60)
inside of the bracket on the Left Pedal Arm (7). Insert
an M8 x 57mm Hex Head Bolt (63) with an M8 Washer
(39) into one side of the bracket. Next, slide a Wheel
Spacer (62), the Wheel (60), and another Wheel
Spacer (62) onto the Bolt. Insert the Bolt through the
other side of the bracket and tighten an M8 Nylon
Locknut (64) with an M8 Washer (39) onto the Bolt.
Assemble the Right Pedal Arm (not shown) in the
same way.
6
9
63
62
62
60
39
39
64
51
7
17
2
15
13
Hole
4
All manuals and user guides at all-guides.com