REDROTOR RC STRIDER 250, Руководство по сборке и инструкция пользователя

Страница: 13 / 26

6. Flip the Strider over and move arm into position so the notch at the end is aligned with the 5” or 6” hole in
the bottom of the center plate. Put a M3 washer on Aluminum M3 x 8mm and insert as shown
from the
bottom of the frame. Screw loosely into captive nut. Push arm inward against screw and angle arm forward
so it sits as far forward as possible in the kidney shaped slot. Tighten Screw fully. Tighten nylon locknut
until arm can only be moved with hard force. Repeat 4x until all 4 arms are assembled.
*Shown below in 5”
configuration. For 6” use the outer holes.