Redmond RMS-4301, Инструкция по эксплуатации

Страница: 11 / 18

11
ENGLISH
Instructions for use
2.
Hair should be combed carefully before styling. We recommend to heat each lock at base
for about 5-6 seconds by setting switcher mode on
1 or 2 position.
3.
Twist the hair on curling iron to all length.
4.
Press «Care» button to fix the hair with cool air . long hair can be untwisted under own
weight, fix each lock with a clamp and let them to get used to that set of form.
attENtiON: usE thE tablE tO chOOsE wORKiNg MODE:
WORKING MODES USAGE
«Сare» – «Cool air». for fixing hairdo for a long time,
exclude hair overdry.
1 – low power of blow and medium
temperature of air-steam.
for fine hair drying and modelling
2 – high power of blow and
temperature of air-steam.
for fast hair drying and modelling
0-switching off appliance is switched off
III. CLEANING AND MAINTENANCE
1.
Make sure the appliance is switched off and disconnected from outlet.
2.
Wait untill the appliance cools down completely.
3.
Clean the appliance with wet soap fabric.
4.
Use soft washing liquids to clean the appliance, do not use abrasive cleaners.
5.
It is prohibited to clean the appliance with spray of water and plunge into the water.
6.
Prior to the first use make it dry.
7.
It is prohibited to wind the cord round the appliance during the storage.
IV. BEFORE CONSULTING THE SERVICE CENTER
Trouble Probable cause Remedy
The appliance does not work
Power cord is disconnected. Insert plug into the outlet
The regime of work of
the appliance does not
correspond with the working.
Put the switcher on one of the
working position.
Cord or plug is damaged. Apply to service-centre
There is an extraneous smell
during the work.
Some elements of the device
are covered with protective
coating, therefore, there can
be an extraneous smell.
Turn off the appliance, wait
until it cools down. Wipe the
nozzles with moist fabric.
If necessary, repeat the
procedure.