RedMax BTR250PL, Руководство по ремонту, Страница: 10 / 64

5. Dismantle the battery housing. See
To disassemble
the battery housing on page 14.
6. Disconnect the wires (A, grey), (B, black) and (C,
red) from the control unit.
B
A
C
7. Loosen the screw and lift off the motor while pulling
the cables out of the shaft.
5.10.2 To assemble the motor
1. Pull the wires through the shaft. Fasten the wires to
a steel wire to make this easier.
2. Fasten the motor to the shaft.
3. Connect the wires to the control unit with (A, grey) at
the top, followed by (B, black) in the middle and (C,
red) at the bottom.
B
A
C
4. Assemble the battery housing. See
To assemble the
battery housing on page 14
5. Assemble the wear guard under the battery housing.
See
To disassemble and assemble the battery
housing wear guard on page 13
6. Assemble the operating handle. See
To assemble
the operating handle on page 14
10 - Repair instructions 572 - 001 - 28.03.2018