4
SAFETY
Air Brake NanoLeak Finder
™
is designed to be used to quickly test and precisely locate leaks in all high pressure
Air Brake, Air Suspension and Air Powered Accessory systems.
DO NOT USE IN EVAP SYSTEM
Air Brake NanoLeak Finder
™
utilizes high test pressure that can damage components in evaporative emission
systems. Redline Detection manufactures low pressure OEM approved EVAP leak detectors such as Smoke Pro
®
Total-Tech
®
[PN 95-0003/B] and Smoke Pro Air Complete
™
[ 95-0051 ] which are specifically designed for Fuel
Vapor Recovery Systems and general engine repair diagnostics.
DO NOT USE IN INTAKE OR EXHAUST SYSTEM
Air Brake NanoLeak Finder
™
utilizes high test pressure that may damage components in Intake or Exhaust
systems. Redline Detection manufactures mid-pressure OEM approved leak detectors such as PowerSmoke Pro
®
[ PN 95-0170 ] and HD PowerSmoke
™
[ 95-0171 ] which are specifically designed for Boosted Intake and Exhaust
Systems and general engine repair diagnostics. Visit www.redlinedetection.com to see the full product range.
SAFETY GLASSES MUST BE WORN
• Always wear proper safety protection for the work being performed, including OSHA standard eyewear
SAFETY AIR BRAKE PRECAUTIONS
•
CAUTION
: Wheel chocks must be installed before testing
• Ensure that the vehicle is secure and stable
• Test to be conducted with ENGINE and vehicle COMPRESSORS off
• All diagnostic work should be performed with the engine off
• Never leave a vehicle unattended while equipment is connected and operating
• Exercise caution when connecting and disconnecting compressed shop air supply
• System testing pressure should never exceed manufacturer’s maximum vehicle operating pressure
TO BE USED BY PROFESSIONAL TECHNICIANS ONLY
• Never use dye / UV dye in air systems because it may coat and / or harm critical sensors, seals,
air dryers, etc.
• Some valving components may have acceptable leak tolerances. Check with the component
manufacturer prior to part replacement.
NanoLeak
™
Finder OEM-Approved NanoLeak Solution
Redline Detection uses an environmentally friendly (non-polluting), contaminant free NanoLeak Solution. For
this reason, the Signature Air can be safely released into the environment after the leak detection procedure is
completed. The NanoLeak
™
Handheld Leak Locator will detect even the most minute leak. Because the Signature
Air atoms in the NanoLeak
™
Solution are so small, it is effective and approved for leak detection using your
NanoLeak
™
Handheld Leak Locator.
The NanoLeak Signature Air is charged into an empty system at a pressure of 100 to 125 PSI (7 to 9 BAR). Once the
source of the leak is located, release system of pressurized Signature Air, perform repairs, retest system to ensure
that the repair has been performed properly.
!
!
!
!
