AN-50 User Manual
6/52
Red
line Communications
…..solving the first mile challenge
.
2.
Important Safety Information
1
Read the user’s manual and follow all operating and safety instructions.
2
Keep all information for future reference.
3
This product is supplied with a grounding power plug. Do not defeat this
important safety feature.
4
The power requirements are indicated on the product-marking label. Do not
exceed the described limits.
5
Replace the fuse with the correct type and current rating.
6
Position the power cord to avoid possible damage and do not overload wall
outlets.
7
Do not place this product on or near a direct heat source.
8
Do not operate this device near water or in a wet location.
9
Use only a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
Disconnect power before cleaning.
10
Protect the unit by disconnecting the power during a lightning storm or if it is not
used for long periods of time.
11
Locate the AN-50 on a stable horizontal surface or securely mount it in a 19”
Telco rack.
12
The T-58 Series Transceiver unit must not be located near power lines or other
electrical power circuits.
13
The T-58 Series Transceiver units must be properly grounded to protect against
power surges and accumulated static electricity. It is the user’s responsibility that
this device is installed in accordance with Section 810 of the National Electrical
Code, ANSI/NFPA No. 70-1984 or Section 54 of the Canadian Electrical Code.
These codes describe correct installation procedures for grounding of the
transceiver unit, mast, lead in wire and discharge unit, location of discharge unit,
size of grounding conductors and connection requirements for grounding
electrodes. It is recommended that the installation of a transceiver unit be
contracted to a professional installer.
