Red
MAX
™
AN-100U
installation guidelines
Doc #70-00059-01-00
Proprietary Redline Communications © 2006
May 30, 2006
Page 32 of 38
Figure 26: IDU Installation - AN-100U Login Screen
Enter the default user name and password:
User Name
: admin
Password
: admin
3.5.2 Ethernet
Settings
It is recommended to configure the AN-100U network address settings before
connecting the terminal to the local Ethernet network. This address information
should be included in the site survey.
1. Click Management Interface in the menu (left of screen) to display the
Management Configuration screen. Adjust the following settings:
IP address
: Network address for the AN-100U.
IP Subnet Mask
: Network subnet mask.
Default Gateway
Address
: Default router/gateway on the local Ethernet segment.
2. Click Save to save the new settings.
3. Briefly depress the reset switch to reboot the AN-100U and activate the new
settings. If the IP address was changed, you will need to enter this new address in
the browser to re-establish contact with the AN-100U system.
3.5.3 Wireless
Settings
The wireless settings must be properly configured before aligning the antenna.
1. Click Wireless Interface in the menu to display the Wireless Interface
Configuration screen. Adjust the following settings:
RF Channel
: Set the operating channel (center) frequency.
Tx Output Power
: Set the power level (dBm) of the radio transmitter.
Requested RSSI
: Set the average received signal strength.
Band Select
: Set the channelization type.
Channel Size
: Set the channel size.
Guard Interval
: Set the cyclic prefix.
Channel ID
: Set the channel identifier. The AN-100U and subscriber station must
have the same settings.