9
3.0 FIRST INSTALLATION, REMOVING THE MACHINE FROM THE
PALLET
Fig. 6
The machine is standing vertically on the pallet. To remove the pallet and lay the machine
horizontally on the ground, proceed as follows
(see Fig. 6)
:
!! NEVER NOT CRAWL UNDER THE MACHINE !!
1. If it has not yet been done, slide adjustable leg 5 downwards and lock it with pin 6 and the
appropriate safety pin.
2. Fasten a cable to the lifting point (1).
Ensure that the cable/crane/lift can lift at least 300 kg (662 lbs).
3. Raise the machine, including the pallet, approx. 50 mm (2”) from the ground.
4. Make sure that the machine is on the point of the pallet 2.
5. Gently lower the machine, in a controlled way, until it fully rests upon the ground.
!! Be careful – KEEP YOUR DISTANCE – The machine MAY shift !!
6. Remove the top rod pin 3 and carefully rotate the pallet 2 around the bottom 3-point pins 4
until they are resting on the ground.
7. Remove the bottom 3-point pins 4 and remove the pallet 2.
8. Connect the machine to the tractor (see chapter 4.0).
Use the correct tractor. See the specifications.
Switch the tractor off and lock the tractor/Verti-Groom combination to prevent it
from driving/sliding away.
