11
5.0 ADJUSTING THE WORKING DEPTH
Adjust the working depth by turning the spindles 4
(Fig. 8)
on the front of the machine, to adjust
the running wheels.
Set both sides of the machine to the same height so the field will be cleaned as evenly as
possible.
NEVER adjust the machine in such a manner that the ground surface might be damaged.
! IMPORTANT ! Before using the machine, first check the working depth while the
machine is stationary!
6.0 TRANSPORTATION OF THE VERTI-GROOM
The user is responsible for the transport of the Verti-Groom behind the tractor when travelling
on public roads. Check the national traffic rules.
On open fields while the machine is raised and if circumstances allow this, the maximum
permitted speed is 20 km/h (12.4 mph) due to the weight of the Verti-Groom.
Higher speeds may endanger the driver and/or other people and even damage the machine.
When the machine is in the raised position, at least 20% of the weight of the
tractor must be supported by the front axle.
7.0 DRIVING SPEED
The driving speed is limited to 12 km/h (7.5 mph).
Higher speeds are not recommended in view of excessive wear and damage that may occur
to the machine and the ground underneath.
8.0 OPERATION OF THE VERTI-GROOM
Before the Verti-Groom is used in the field, the following must be checked:
1.
Are there any loose objects in the field? Remove these first.
2.
Are there any slopes? The maximum slope this machine can work on is 20
degrees.
3.
Always work downhill.
Is there any danger of flying objects, such as balls, which may distract the
attention of the driver? If so, do NOT use the Verti-Groom.
4.
Is there any danger of sinking or sliding away? If so, delay the work until the
conditions are more favourable.
5.
A field can be done several times in the same direction or different directions to
achieve better cleaning.
6.
Do not make sharp turns; preferably drive in straight lines to avoid damaging the
machine and/or the ground.
7.
Do not set the machine too deeply; this can result in undesired damage on the
ground.
