32
17.0 OPTIONS, TURF HOLD-DOWN KIT
1
2
3
Fig. 28
You can use a turf hold-down kit when the turf layer comes loose.
Two turf hold-down kits can be supplied for the 12 mm tines under number 211.700.002.
The Verti-Drain
®
7007 Hydro is equipped as standard with a pre-mounted main beam on
which the turf hold-down fingers can be mounted.
The kit consists of a set of turf hold-down fingers for 12 mm (1/2”) tines and the mounting
material, consisting of a number of bolts and nuts.
INSTALLATION OF THE TURF HOLD-DOWN KIT (see fig. 28):
- The ordered set comes with plates 2. Fasten the plates to the main beam with bolt 3 and
nut 1. Align the plates with the tines through the slotted holes in the plates.
- When the plates have been in use for some time and are bent in one direction, reverse
their direction.
OTHER SUGGESTIONS:
- When the tines no longer sit in the middle of the machine, they may contact the sides of
the slots. Re-align the pin blocks.
- If the tines contact the front side of the hole (during use), check the length of the
drawbar.
Never crawl under the machine. Ensure the machine is properly blocked!
