14
1
2
3
3
4
Fig. 13
4.0 OPERATING DEPTH ADJUSTMENT
Carry out the following to adjust the operating depth: (see fig. 13)
1. Lift the Verti-Drain
®
unit to the highest position.
2. Block the whole machine with the foot brake in the parking position.
3. Switch off the Verti-Drain
®
and remove the key from the ignition.
4. Untighten the bolts (1) a little. Be careful. Do not loosen too much since then the bolts
will fall out from the locking strip (2).
5. Adjust the height of the front roller by turning clock- or counter clockwise the spindles
(3). Each rotation is 4 mm (0.16”). The sticker (4) on the side of the machine gives the
depth setting.
6. When the required height has been reached, re-tighten the bolts (1).
@ Never adjust one side by more than 4 turns. Before continuing, compensate the other
side.
@ A spanner is included in the machine’s toolbox.
@ The depth adjustment on the stickers only applies when 150 mm (6”) long tines are used.
When shorter tines are used, subtract the difference in length, compared to 150 mm (6”),
from the value shown on the stickers.
@ The spindle and the nut must be cleaned every 100 hours and sprayed with thin oil that
does not attract dirt.
