4
If present, check the hydraulic pipelines regularly and replace these when the hydraulic
pipelines are damaged or appear old. The pipelines that are replaced should comply with
the technical requirements of the manufacturer.
If a hydraulic installation is present, you should
always
make it pressure-free
before
working on this installation.
NEVER
use the Verti-Cut in the absence of the safety stickers.
NEVER
crawl under the Verti-Cut.
If necessary, tilt the Verti-Cut.
NEVER
step off the tractor while the motor is running.
In case of maintenance, adjusting and repairs, it is necessary to block the Verti-Cut in
order to prevent sinking away, driving off and/or sliding off.
Always switch off the tractor motor, take the tractor’s key out off the ignition and
disconnect the Power Take-Off (PTO)
in case of maintenance, adjusting and repairs
(Figure 2)
.
Figure 2
With regards to the safety of the machine and the user, use only original Verti-Cut parts
for maintenance and repairs.
Only authorised technical personnel may carry out repairs to the
Verti-Cut.
Keep a record of the repair activities.
(5) The general applicable health & safety (Dutch: ARBO) regulations must also
be followed in addition to the instructions in this user manual.
Relevant traffic regulations also apply in case of using public roads.
Transporting persons is not permitted!
Do not use the Verti-Cut in the dark, in heavy rain/storm or on slopes with an angle larger
than 20 degrees.
(6) All persons that are going to operate the Verti-Cut must be familiar with all the
functions and control elements of the Verti-Cut
before
starting any work
activities.
Attach the Verti-Cut to the towing vehicle according to the regulations.
(Danger of injuries!)
Check whether you have a clear field of vision – both close by and far away –
before
you
depart.