Redexim RINK SP950, Руководство пользователя

Страница: 17 / 17

17
Attention: Excessive tightening causes a permanent idling of the conveyor
belt, the brush and the traction drive. Should this be the case, please free up
tightening.
Trouble Shooting (Problem analysis)
Problem Cause Solution
Slide does not open Fastening elements too tight
Slider is jammed Loosen fastening elements
Check slide opening
There is no material
coming out of the
machine Slide is closed
Drive is not switched on
Conveyor belt is slipping Check and open slide (see page 8)
Check control lever (see page 7)
Tighten conveyor belt
(see page 10)
Engine is not running No gas in the tank
Refill gas
Observe instructions of the engine
manufacturer
Band and brush rotate
in empty state (idling
mixture) V-belt too tight
Release V-belt tightening
(see page 16)
Conveyor belt is
slipping
Conveyor belt not tight enough
Machine is overloaded Tighten conveyor belt
(see page 10)
Do not overload the machine
Conveyor belt and
brush roller do not
rotate V-belt tightening too weak Increase V-belt tightening
(see page 16)