SmokeSight SS10MANN V0.6
Page 5
Ready to slide
Engages with a ‘click’
Slide
8.
Turn on the mains power and check that the green and red LEDs function. The Green LED should illuminate to
show mains power present. The red LED will flash every 5mins and 45secs to indicate correct operation and that
the battery backup is functional.
9.
Press the Test+Hush button to check that the alarm sounds.
10.
If tamper prevention is required, slide the Tamper Clip between the ceiling and the mounting base, locking tab.
The Tamper Clip can be removed by gripping it with pliers and pulling the clip away from the smoke alarm.
Loose Tamper Clip
Tamper Clip Installation
Tamper Clip Installed
Installation is not complete until the green and red LEDs are functioning correctly and the alarm has been checked
for correct operation.
7
Overview
Once the mains supply is connected or the backup batteries are installed correctly, the smoke alarm is operational. If
smoke is detected the alarm will sound and the red LED will flash rapidly. This will continue until the air is cleared of
smoke. During normal operations the red LED flashes once every 5mins and 45secs to indicate that the smoke alarm
and battery backup is functional. The green LED is illuminated when the mains power is applied.
7.1
When the Alarm Sounds
1.
Alert small children in the home.
2.
Leave immediately by your plan of escape. Don’t waste time getting dressed or picking up valuables.
3.
When leaving, don’t open any inside door without first feeling its surface. If hot, or if you see smoke seeping
through cracks, don’t open that door! Instead, use your alternate exit. If inside the door is cool, place your
shoulder against it, open it slightly and be ready to slam it shut if heat and smoke rush in.
4.
Stay close to the floor if air is smoky. Breathe shallowly through a wet cloth if possible.
5.
Once outside, go to your selected meeting place and make sure everyone is there.
6.
Call the Fire Brigade from your neighbour’s home - not from yours!
