SmokeSight SS10MAMA V0.5
Page 5
8.
If neither the Radio Interlinked nor Auto Test
feature was setup then apply option card power
by installing 2xAA batteries into the into the top
battery bay of the smoke alarm
9.
Apply smoke alarm power by installing 2xAA
batteries into the into the bottom battery bay of
the smoke alarm (see also ‘Replacing the Backup
Battery’).
Option Card Batteries
Smoke Alarm Batteries
10.
Engage and slide the smoke alarm along the mounting base until it is fully home and it ‘clicks’. The smoke alarm
will only travel home and click if the smoke alarm batteries are installed. Note: Do not attempt to slide the alarm
onto the mounting base unless the smoke alarm batteries are installed as damage may result.
Ready to slide
Engages with a ‘click’
Slide
11.
Turn on the mains power and check that the green, red and white LEDs function. The Green LED should
illuminate to show mains power present. The Red and White LED will flash every 5mins and 45secs to indicate
correct operation.
12.
Press the Test+Hush button to check that the alarm sounds.
13.
If tamper prevention is required, slide the Tamper Clip between the ceiling and the mounting base, locking tab.
The Tamper Clip can be removed by gripping it with pliers and pulling the clip away from the smoke alarm.
Loose Tamper Clip
Tamper Clip Installation
Tamper Clip Installed
Installation is not complete until the green, red and white LEDs are functioning correctly and the alarm has been
checked for correct operation.
