RedBack Lasers ARL516G, Инструкция по эксплуатации

Страница: 8 / 12

8
www.redbacklasers.com.au
Vertical Rotation Operation for Site Layout
ARL516G
TM
OPERATING INSTRUCTIONS
The ARL516G
TM
can be used on its side for vertical alignment or together
with the dot laser out of the front to produce a 90 degree square for site
layout. The ARL516G
TM
can be placed on its side with the datum marker
over the correct point and the laser levelled with the bubble vial and manual
levelling knob.
For site layout squaring;
• Place datum marker over the datum point marking the conjunction of
the 90 degree lines.
• Align laser housing so dot is striking target point along the one line of
the 90 degrees, adjust the housing of the laser left and right to achieve
this.
• Once the dot is on the target use the receiver to pick up the rotating line
on the second line of the 90 degree. Your square is now set.
Rotation Scan Modes - For Indoor Visibility
The Scan Mode stops the laser from rotating and toggles the beam left to
right, intensifying the beam making the laser more usable indoors as a visible
laser. You can set the scan angle to 0
o
, 20
o
and 40
o
and shift the beam both
left and right. The Scan Mode can be operated by both the Control key pad
on the laser and also the Remote Control.
• Press the Scan button to enter scan mode, LED will flash.
• The first press, area scan 20 °, second press 40°, third press 0°, fourth
press 20° etc….
• Move the scan line by pressing Scan Control buttons.
• Press and hold Scan Control button to rotate the scan line quickly.
• To return to rotation mode press the Rotate button .