21
4
Getting Started
EN
4.1
First Steps
Open the housing by removing the end cap, on which the USB
plug is located. Slide out the plastic edging on the sides.
Carefully plug a 3,5” hard disc onto the SATA plug. Make sure,
that the hard disc is configured as “Master” (Master is usually
default and the instruction is usually on the housing of the
hard disc). Carefully slide the disc into the housing. Secure
the hard disc in the housing by using the four larger screws in
the slits at the side of the enclosure. Slide the plastic edging
back into place, covering the screws. Secure the plastic end
cap by screwing the small screws into the holes left and right
on the slim side of the housing.
Connect the power supply to the enclosure and then plug it
into a mains socket. Connect the unit to a free USB port of
your PC using the supplied USB-Cable.
Switch the hard disc on by using the switch in the end cap.
The LED will blink, when the hard disc is addressed. Wait a
moment for your system to recognise the disc and install the
corresponding drivers. Your system will confirm when the
external disc is ready for use.
