Red Ember WTL257-1, Руководство пользователя

Страница: 7 / 16

7
ASSEMBLY INSTRUCTIONS
3
3. Place the Burner Bracket (D) onto the assembled panels. Make
sure the burner controls are facing towards Side Panel 3 (G) with
the small hole and set Burner (C) into Burner Bracket. Remove
the Cotter Pin from the end of the Connecting Rod (S), then insert
the Connecting Rod (S) though the hole in Side Panel 3 (G) and
into the Burner (C). Secure the Connecting Rod (S) to the
Burner (C) with the Cotter Pin.
Note: The Control Knob is located on the end of the Connecting
Rod and will be used for operation of the burner.
4
L
Bolt (8*60mm),
Hardware Used
x 4
Washer,
Spring washer
Nut(M8)
,
O
N
4. Affix the Bolts (8*60mm) (L) to the underside of the Table
Top (B) with the Screwdriver (N). Then turn the Table Top over
and align the Bolts with the holes in the assembled panels.
Place the Table Top on the assembled panels so the Bolts are
sticking through the holes and secure on the underside with
Spring Washer/Washer/Nut (L) using Wrench (O).
Now go back and tighten all Bolts/Nuts securely on the appliance.
L
Cotter pin
E
G
F
H
D
C
burner control