C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 7 , R EV - K
|
1 8
REDRAY PLAYER OPERATION GUIDE
CHAPTER 4:
REDRAY SETUP
SET UP YOUR REDRAY
1. Install two (2) AAA batteries (included) into the IR Remote Control.
2. Attach the 802.11 Antenna (wireless transceiver) to the 802.11 Connector.
3. Connect an HDMI 1.4 cable (also known as an HDMI High Speed cable) to an HDMI input port on your monitor,
and connect the other end to the REDRAY
®
port that corresponds to your monitor configuration:
4K (UHD) monitor
: Plug an HDMI 1.4 cable into the
VID D
port.
HD monitor
: Plug an HDMI 1.4 cable into the
HDTV
port.
Four HD monitors
: Plug HDMI 1.4 cables into the
VID A
,
VID B
,
VID C
, and
VID D
ports (One (1) HDMI 1.4
cable is required for each port).
For more information, go to
"Monitor Configuration" on the next page
4. If using a standalone audio receiver, plug an HDMI 1.4 cable into the
AUDIO
port, and plug the other end of the
cable into an HDMI input port on your audio receiver.
5. Plug an Ethernet cable into the
NETWORK
port (Upper) and connect the other end to an Ethernet port on one of
the following devices:
Internet router.
Wireless network extender.
Any other device that is designed to distribute Ethernet, such as a powerline Ethernet adapter.
NOTE:
For optimal media download speeds, connect to your network using an Ethernet cable, and not a wireless
connection.
6. Plug the IEC Power Cord into the
AC power
connector.
7. Toggle the
Power Switch
to turn on the REDRAY.
The POWER LED on the front panel illuminates red and the STATUS LED flashes orange.
The REDRAY powers up in about three (3) minutes.
NOTE:
For more information on general setup, refer to the REDRAY QUICK-START GUIDE included.
