CONNECT WITH ETHERNET
The default and recommended setting for Ethernet is AUTOMATIC (DHCP). In this mode, the REDRAY receives its IP
Address from your network router.
CONNECT WITH DCHP
1. Navigate to
SETTINGS
>
NETWORK
.
2. Select
Wired (Ethernet - Upper)
.
3. Select
Automatic (DHCP)
.
The REDRAY communicates with the router for about 10 seconds to obtain your network IP address. You cannot
select anything on the REDRAY on-screen display during these 10 seconds.
Figure: Wired (Ethernet - Upper)
After the REDRAY obtains the IP address, the panel on the right side of the screen closes and the IP address displays
on the NETWORK screen.
NOTE:
If the REDRAY is connected to a router through an Ethernet cable and a wireless connection, two (2)sets of IP
addresses display on the NETWORK screen.
Figure: Network IP Address
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
9 5 5 - 0 0 1 7 , R EV - K
|
2 4
REDRAY PLAYER OPERATION GUIDE
