Recsea WHS-RX1, Руководство пользователя

Страница: 9 / 12

of non-genuine options are NOT covered under warranty.
※
The Accessory Shoe on top of the housing can be used for installation of a target light.
Please be mindful of the weight of the light(s) you intend to use. For heavy lights and
strobes please use Seatool/Recsea genuine tray and grip assemblies.
※
Please refrain from using lights attached to the Accessory Shoe as a carrying handle.
CAUTION! Damage is irreparable.
MAINTENANCE
CAUTION! Allowing saltwater and contaminants to dry on housing can damage functions and
O-rings possibly causing water leakage. Clean with fresh water only, using a soft, dry cloth to
wipe away water.
※
A complete housing overhaul is recommended once every year.
1. After use in salt water, wash off salt and other contaminants by soaking empty housing
thoroughly in a bucket of fresh water (lukewarm) for 10 to 20 minutes.
2. Manipulate all buttons and dials several times to flush out salt deposits and other
contaminants.
3. Wipe any water off housing with a soft dry cloth.
4. Open Back Cover.
5. Using the O-ring Removal Pick, remove O-ring.
6. Clean O-ring groove and contact surface using a clean cotton swab. DO NOT clean
housing or Lens Port with volatile organic solvents or chemical cleaning agents such as
thinner, gasoline, and benzine, etc.
7. Perform O-RING GREASING & MAINTENANCE as instructed below before re-installing.
O-RING GREASING & MAINTENANCE ( 1)
※
CAUTION! This housing uses one (1) O-ring. Please be sure to install O-ring as shown
below. Failure to do so will result in water leakage.
1. Using the O-ring Removal Pick, remove O-ring.
2. Clean sand, salt, other contaminants and old grease from O-rings.
3. Clean O-ring groove and O-ring Contact Surface using a clean cotton swab.
4. Visually and physically check each O-ring by running it through finger tips, feeling for
cuts, cracks or any other defects that may cause leakage. Such defects will cause water
leakage, if found be sure to replace the O-ring. Be careful not to stretch or pull the O-ring
too much.
5. Squeeze a rice grain sized bead of silicone grease between your thumb and forefinger.
Taking care not to pull or stretch the O-ring too much, uniformly spread grease on O-ring.
Too little grease may cause the O-ring to twist in the groove, possibly causing water
leakage.
7.