Page 7
The RX-100SA has two duplication modes: 1 to 1 Duplication and Multi-Master
Duplication. A hard drive must be installed to operate in Multi-Master Duplica-
tion mode. The unit is designed for easy installation of an optional hard drive.
1 to 1 Duplication is the default duplication mode and is the only duplication
mode available if a hard drive is
not
installed. In 1 to 1 Duplication mode you
simply load a master disc in the source drive (located on the left side of the
unit), select 1 to 1 Duplicate (press Enter), set the quantity of discs to dupli-
cate, and press Enter. The RX-100 then cycles your blank discs from the input
tank through the burner and ejects completed discs into the output tank. Re-
fer to page 10 for more complete instructions.
Multi-Master Duplication Mode allow you to automate the duplication of sever-
al small jobs in one easy step. Simply create sets of master and blank discs
and place them in the input tank. Select Multi Duplicate and press enter. The
RX-100 will automatically load the master disc to the hard drive and then
make copies until it either runs out of blank media or comes to the next mas-
ter disc. See the illustration below for further clarification.
Duplication Modes & Installation of Optional Hard Drive
Master #1
Blanks for
Master #1
Master #2
Blanks for
Master #2
Figure 5.2 Multi-Master Mode
