Record STM 20 RED/DUO, Руководство пользователя

Страница: 21 / 36

Control module STM 21
4
B6_Control_SYS20_EN_V1.3.doc
Art. Nr. 102-020401135 21 / 36
JP4 Standard D-ST & EST L
Re-plugging for monitoring devices EST R
– subsequently reboot of control necessary
Light-emitting diode Meaning
LD1 Red control-LED
For multifunctional key S1 – blinks when key is pressed
LD2 Red

Change plugging to reverse rotational direction (EST-R)

Then resetting STM is required
LD3 Green + 24 V

Is on, if 24 volt circuit OK

Comes off in case of by-pass in 24 volt circuit
LD4 Green + 32 V

Is on, if system connected to mains voltage
Multifunctional key
Function, after impulses have been given
1 puls Activates an opening function (AKI)
2 pulses Calibrating ELS
3 pulses Calibrating door parameters
4 pulses Entering programming level
5 pulses

Battery emergency reaction, as long as system is dis-
connected from mains

Battery test in case of mains connection
8 pulses Loads default values of door type selected
9 pulses Back to factory settings
(afterwards an emergency stop or a reset must be actuated
within 10 seconds) The function emergency-stop with reset
can only be actuated if the INPUT/OUTPUT parameter
Emergency-Stop with Reset is active!!
14 pulses Hardware reset is performed within ca. 12 seconds
Connector designation
Connections
J1 Mains plug
J2 Terminals 25 – 28

für BDE-D
J3 Terminals 1 - 12:
Functions according to wiring diagram 021.110.649_D
J4 Locking device
J5 Battery
J6 Motor brake
J7 ATE Motor
J8 CAN-bus
J9 CAN bus plug for FPC-servicing
J10 Encoder motor
J11
Extra printed circuit board ELS (ZLP-ELS)
J12 - 13 Reserved for future modules
J15 Extra printed circuit board BAT (ZLP-BAT) for lead-acid bat-
tery