Record STM 20 RED/DUO, Руководство пользователя

Страница: 14 / 36

Control module STM 20 RED/DUO
3
B6_Control_SYS20_EN_V1.3.doc
Art. Nr. 102-020401135 14 / 36
JP4 On RED and DUO installation
D-ST & EST-R Factory setting
EST-L
Fixing connecting clamp to upper part of toothed belt - Shunt
position remains unchanged !
JP5
Standard Master opera-
tion mode
Slave – only in case of two STM
Light-emitting diodes Meaning
LD1 Ground – red control-LED

Ground – must light up, if protective earth screw is with-
drawn

Otherwise grounding is on
LD2 green + 24 V

Is on, if 24 volt circuit OK

Comes off in case of by-pass in 24 volt circuit
LD3 green + 32 V

Is on, if system connected to mains voltage
LD4 red control-LED
For MF key S1 – is blinking, if button is pressed
Multifunctional key Function, after pulses have been given
1 pulse Releases an opening movement (AKI)
2 pulses Calibrating ELS
3 pulses Calibrating door parameters
4 pulses Entering programming level
5 pulses
RED

Redundancy test, if system connected to mains voltage
DUO

Battery emergency reaction, as long as system discon-
nected from mains

Battery test in case of mains connection
8 pulses Loads default values of door type selected
9 pulses Back to factory settings (afterwards emergency stop must be
actuated within 10 seconds)
14 pulses Hardware reset is performed after approx. 12 seconds
Connector designation Connections
J1 Terminals 25 – 28

for BDE-D
J2 Terminals 1 – 12:
Functions according to wiring diagram 102-020110534
J3 Terminals 13 – 17 (only used with RED applications):
With DUO-applications the terminals 13 – 17 are used as
additional inputs
Functions according to wiring diagram 102-020110534
J4 Battery 1 (used for DUO and RED applications)
J5 Battery 2 (only used for RED applications)
J6 Locking
J7 Motor brake
J8 ATE motor 1 (The DUO-application can be driven with 1 mo-
tor only)
J9 ATE motor 2
J10 CAN bus / CAN sensors