Recon BLOCKAGE+, Руководство по установке

Страница: 18 / 35

Installing the Work Switch Recon Blockage Plus
™ Installation Manual
600840-000069, rev 1.0 Page 18 of 35
Installing the Work Switch
The work switch is a mercury switch, meaning the switch is engaged when the mercury inside is
tilted toward the wires and it contacts the electrical leads.
Mount the work switch (353070-000534) in a location where the work switch tilts from one end
to the other when the toolbar is changing from raised to lowered positions.
Figure 17: Work switch functionality
Determining Work Switch Method
The work switch uses one of two methods to determine when the implement is in the ground:
•
Default method
o
The work switch is tilted toward the wires when the implement is in the ground .
o
The work switch is tilted away from the wires when the implement is out of the
ground .
•
Inverted method
o
The work switch is tilted away from the wires when the implement is in the
ground .
o
The work switch is tilted toward the wires when the implement is out of the
ground .
Take note of your work switch method. It will be configured during system configuration in the
app. See the Recon Blockage Plus
™ Operator’s Guide (Intelligent Ag document number
600890-000075) for instructions.
Verifying Work Switch Installation
Refer to Section 2.3 of the Operator’s Guide for instructions to verify that the work switch was
correctly installed and configured.