27
26
4.
Excess belt webbing should
be stored away from the seat/
base connection.v
4
Lock Off Installation
Must be used for Non-Locking ELR Lap/Shoulder Belt
Some older vehicles (typically pre-1996 model year) have lap/
shoulder belt systems which remain loose and cannot be locked.
These systems use emergency locking retractors which lock
only during a sudden stop or crash. Check your vehicle owner’s
manual to determine which type of seat belt system is in each
seating location. There may be a label located on the door side
of the seat belt with instructions for use with a child restraint.
The Performance Crossover is equipped with belt lock offs that
MUST
be used with these types of belt systems.
Base Installation - Lap Belt
Base Installation - Non-Locking ELR Lap/Shoulder Belt
1. Position the base on the
forward-facing vehicle seat
with belt path against the back
of the seat.
2. Fully extend the seat belt
webbing and route the lap/
shoulder belt through the
openings in the base as shown.
Make sure the belt is not twisted,
then buckle the seat belt.
*NOTE: The lap/shoulder belt is
routed over the stored LATCH strap.
1
2
WARNING!
DEATH or SERIOUS INJURY
can occur
