REBOTEC /
BA-Nr.:02.01.119/2021-11-A01
- 6 -
EN
the hole. Move the aluminium tube (C) to the de-
sired position. Have the push button (B) snap into
the hole.
•
Tighten the screw connection (A) by turning it
clockwise. By tightening the screw, you reduce the
noise during use.
9.2.
Setting armrest / forearm length
•
There are three setting options for adjusting the
forearm length (A= regular/B= short/C= long)
•
Loosen the cap nut (1) with an open-end wrench
SW10, unscrew and pull out the screw (2) com-
pletely. Select the adjustment, insert the screw and
screw the cap nut tight again.
9.3.
Setting the handle
•
The position of the handle can be variably ad-
justed.
•
Hold the handle (A) with one hand. With the other
hand, slightly loosen the screw (1) with the Allen
key / SW5 (2).
•
Push the handle forward, turn it to the desired po-
sition (left/right), align it centrally and tighten it
again.
9.4.
Setting armrest / angle position
•
The position of the forearm can be adjusted by
changing the inclination of the armrest.
•
Slightly loosen the screw (1) on the clamping bush
(2) of the support fork with an Allen key/SW4 (3).
Press the armrest down into the desired position
with your hand (A). (max. inclination adjustable to
the stop (B))
•
Tighten the screw (1) again.
Notice!
•
Adjustment is also possible with different forearm
lengths (see point 2).
Before
After
9.5.
Adjustment of the Velcro strap
•
The Velcro strap (A) is used to fix and fasten the
forearm to the armrest (B).
•
Loosen one end of the Velcro strap. Place the fore-
arm into the armrest.
•
Close the Velcro strap again. The Velcro strap
should only rest on the forearm with slight pres-
sure!
C
A
B
B
C
A
2
1
1
A
2
3
Do not loosen this screw connection!
2
1
Stop
A
B
B
A
