Version Number: RBM-1350 20210712A2
7
Step 2. Star wire inching.
The welding machine is installed with internal wire feeder. Open the side panel, fix the wire spool to the
roller in the direction that it could rotating anticlockwise. Match the driving roller with your wire type and
size. Turn the plastic roller holder anticlockwise to take it off. Then change the driving roller.
insert the wire through the plastic tube then into the driving rollers and push it till the machine output
connector. Lock the driving rolls properly.
The welding torch is installed well already, press the torch switch. In this case the wire is push slowly at
speed 8 m/min. Release the switch, it stops wire inching.
Pay attention, welding wire coming out of the current contact tube may hurt the hand, the eyes or the
face.
Step 3. Set the welding value.
Adjusting knob
Turn the knob to set the current. The power source is synergic designed, After the current is configured,
the machine automatically matches the feeding speed.
Abnormal indicator
The led is flash when over current, and light on when over heat.
Step 4. Start Welding.