Assembly Instructions Page 2
Unfold arms on Seat Platform Assembly , place bottom
side up over Seat Pad and attach Seat Pad around
the bottom of Seat Platform Assembly by weaving the
webbing strap through the “Ladder Lock.” Pull webbing
firmly to tighten.
3
4
6
5
3
Carefully turn Seat Platform Assembly with Seat Pad
attached right side up. Attach Arm Rest Covers
to right and left Arm Rests. Attach Shooting Rail Cover
to front shooting rail (as shown Above).
Install M6 Quickclip into rail tube of Foot
Platform Assembly in order to lock notched
cable in place. Install by sliding Quickclip pin
through BOTH attachment holes at the end of
rail tube. Once though, flex and fasten metal
loop onto the end of pin (as shown Above).
NEVER
remove this quick clip while this
Climber is in use. If these Quick Clips are
missing or not correctly installed,
DO NOT
use this climber.
4
6
Install Foot Platform Assembly onto tree by wrapping
the cable around back of tree and through rail tube
“Bullet Drive System” (as shown above).
To tighten, pull on cable allowing “notched” ends to slide
into the locking “slotted” end of rail tube. Pull until the
Foot Platform Assembly is firmly locked to tree trunk.
5
BOTTOM
TOP
Ladder Lock
Notched ends of
cable locking
into slotted
rail tube
Bullet Drive System
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Model: RTCS-421
Deluxe Aluminum Climbing Stand
Customer Service Department 1-866-972-6168
www.primalvantage.com/realtree
©2021 (rev. 1/21)
