Ameba-Pro KVS Getting Started Guide
Getting Started Guide All information provided in this document is subject to legal disclaimers. © REALTEK 2020. All rights reserved.
20
7
KVS Producer Demo
7.1
Get Device Log
Install Tera Term or other terminal emulator to get device log
Fig 7-1 Hardware setup
The serial port is same with ImageTool that get from 5.3.2 or use device manager to get the right serial port of device.
7.2
Run KVS Producer Demo
Default setting of SDK may not enable Producer demo, so please refer to Ch 3.3 to check whether KVS Producer Demo is enabled. Once the
AmebaPro EVB has rebooted, the application will automatically start run Producer demo and put media to KVS.
7.2.1
Connect to WIFI AP
In order to run the example, AmebaPro should connect to the network. It can be achieved by run the AT command in uart console. Please refer
to the steps below:
ATW0=<WiFi_SSID> : Set the WiFi AP to be connected
ATW1=<WiFi_Password> : Set the WiFi AP password
ATWC : Initiate the connection
