ReActiveMicro MicroDrive Turbo, Руководство пользователя

Страница: 38 / 55

MicroDrive Turbo 31 ReActiveMicro
New Hard Disk Setup
When there is no valid configuration data found at start-up, the program assumes
that a new hard disk was connected and needs to be configured. In this case, the
program automatically does all the necessary things to set up a valid configuration
including default operating parameters (it is basically the same thing as pressing
 
, re-read configuration parameters from hard disk). The only thing you
have to do is to set up one or more partitions by entering the partition editor and to
save your configuration data on the hard disk. As the last step, use a formatting
utility like the FINDER, the Advanced Disk Utilities or PROSEL-16 to format your
partitions.
The MICRO.INSTALLER does not check your configuration to see if a second
drive (Slave) Drive is present. If you need a second drive to be configured,
choose menu item CHANGE drive and the program will behave just like it has
when dealing with the first drive.
Once you have run the
MICRO.INSTALLER
to create a new hard disk configuration,
there is no need to launch it again from the installation disk.
The program writes itself on your hard disk into a safe area which cannot be
accessed from any PRODOS or GS/OS program. At any time when you boot from
your hard disk, you can choose launching the utility program first. When you reboot
your computer, just hold down the

key or the
Option
key and press
I
to run the
MICRO.INSTALLER .
If you prefer to run the MICRO.INSTALLER from a program launcher, you can keep
a copy on your hard disk.
Several additional options for setting up operating parameters can be found in this
program. The functions are not implemented yet and won't be of any use for correct
hard disk operation. These options will be added in a later revision of the card's
software.