UNPACKING AND INITIAL ASSEMBLY
15
It is easiest to do this while standing, because then you have the floor
as a counter-support. (Picture 3.2).
4.
You need to rotate the two short ends of the spar slightly inwards
and then release the locking mechanism of the snap-locks to engage
the snap-locks. The further you pull out the main tube at the top of
the spar, the easier it is. The torsion increases with a wider
adjustment of the wheel frame. Therefore, it is easiest, when the
mainframe is mounted on the narrowest hole position of the
mainframe.
Wheel assembly
The wheel mounts of the reacha are designed for wheels with a hub
width of 100mm, with a minimum diameter of 20 " and a maximum
diameter of 26". The width of the tires must not exceed 4.0 ". The
tightening torque for mounting must be between 5.0 and 7.5 Nm. Only
the wheels that meet these requirements are to be used, otherwise
there is a risk of damage, injuries and accidents.
Check the wheels for a secure position before every ride. Otherwise it
can cause damage, serious injuries or accidents with life-threatening
danger.
WARNING !
WARNING !
