* Adjust
Brightness
as required using +/- button on the right side of the LCD Monitor.
*
The Sensitivity of Sound Trigger
can be adjusted by Baby Camera
’
s TRIGGER LEVEL knob.
* The most common source of interference are microwave ovens, WiFi products. Try to avoid
mounting the LCD Monitor near a microwave oven or other source of RF interference such as
cordless phones, WiFi products.
* To avoid the interference from camera, we recommend you set your WiFi at channel 10.
Multi-camera Operation ///
The Wireless Baby Care Color Camera System (CMS2724L) is designed to work with up to
3 Cameras. Additional Camera are sold separately.
IMPORTANT:
When using more than one Camera, make sure each Camera is assigned to a specific channel
by adjusting the corresponding DIP switch down.
Accordingly the DIP switch located on the bottom of the LCD Monitor should be
adjusted to reflect the channel in use.
Sound-Trigger Cameras ///
The baby Camera has the
Sound Trigger Feature
. When a Camera detects sound, an audio
alert sounds on the LCD Monitor(The audio alert is adjustable). The Sensitivity of the Sound
Trigger can be adjusted by the Baby Camera
’
s TRIGGER LEVEL knob on side of the Camera
head.
Operating Modes ///
The system can be set to operate in one of 3 modes:
SCAN
,
AUTO
or
MANUAL
.
The desired operating mode can be selected using the buttons on the front panel of the LCD
Monitor.
SCAN
Pressing the
SCAN
button places the system in Scan mode. The LCD Monitor screen blanks
into a standby mode while the system continuously scans active Cameras. If a Camera detects
sound above the preset sound trigger level, the LCD Monitor displays the Camera picture and
the beeper will sound. Four minutes after the last detection, the screen returns to standby mode
and the LCD Monitor resumes scanning. Pressing the
MANUAL
or
AUTO
button will cancel
this mode.
