RCm ALFA, Инструкция по эксплуатации и техническому обслуживанию

Страница: 78 / 88

78
(*) = Machines with electric motor only, (**) = Machines with petrol engine only
SAFETY INFORMATION
!
Cleaning:
When cleaning and washing the machine, take care when using aggressive detergents, acids, etc.
Follow the instructions provided by the detergent producer, and wear protective clothing if appropriate (e.g. overalls, gloves, goggles, etc. - see
EEC directives on this subject).
!
Explosive atmosphere:
The machine is not constructed to work in environments where there is a risk that there might be explosive gases, dusts or vapours, and so its
use in an explosive atmosphere is FORBIDDEN.
!
Disposal of harmful substances:
Comply with the laws in force on waste disposal and treatment when disposing of the material collected, the machine fi lters and spend material
such as batteries, motor oil, etc.
!
Scrapping the machine:
If the machine is scrapped, subdivide the types of materials of which it consists (02/96/EEC Directives) according to the disposal method, so that
they can be disposed of in accordance with the laws in force.
Consign hazardous materials such as batteries, spent oils, etc to operators authorized to dispose.
TROUBLESHOOTING
Fault Cause Corrective action
The sweeper fails to pick up large particles of
dirt or leaves traces of dirt behind. Excessive working speed Decrease working speed
Brushes pressure too light Adjust brush pressure
Brushes worn Lower or replace brushes
Bristles bent, or string or wire, etc., entangled
in brushes. Remove string or wire and straighten bristles
in warm water.
Sweeper leaves dust on fl oor or dust comes
out from side fl aps. Filter clogged Clean fi lter
Flaps worn out or broken Replace fl aps
Dust comes out of the vacuum fan Filter torn Replace fi lter
Sweeper throws dirt forwards Front fl ap broken Replace fl ap
Rapid brush wear Excessive brush pressure Reduce brush pressure
Main brushes noise diff erent or excessive. Material wound around brushes Remove entangled material
The main brushes does not turn Transmission belts broken Replace belts
Battery does not maintain its charge (*) Electrolyte level low Top up electrolyte level
Battery cell burned out Replace battery
Motor over-loaded Check motor current absorption
Battery terminals loose Check or tighten battery terminals
Material entangled in main brushes. Remove entangled material
Bearings seized Replace bearings
Excessive brush pressure Reduce brush pressure
Battery discharges quickly (*) Insuffi cient charge time Increase charge time
Battery terminals loose or oxidized Clean terminals and tighten
The engine does not start (**) oil level too low top up oil level
- Read the engine use manual of the construc-
tor.