RCF HDL 50-A, Руководство пользователя, Страница: 24 / 28

A maximum of 4 x TOP cabinets are allowed to be set up as
ground stack.
The assembly of HDL 50 in stacking uses the same flybar as the
hanging process. Proceed as follows:
Remove the pick-up front bracket and remove the laser/
inclinometer bracket.
Fix the stacking bracket in the hole number 20 of the flybar
and orientate it as shown in fig 2.
Place the first module fixing the front bracket into the fixing
point “A” of the flybar using the quick lock pins of the flybar.
Secure the front brackets by compression.
Turn the rear stacking bracket of the flybar and select the
proper angle. The correspondence of the bracket’s holes is the
following:
Insert the locking pin in the proper position
Fix the next module with the front quick lock pins. Lift the rear
part of the module, insert the locking pin in the proper position
and release the module leaning with the right angle.
Repeat this operation for the following modules.
STACKING PROCEDURE
Stacking Bracket Rear Rigging
Frame
4 4
3 3
2 2,2
1 1,4
0 0,2
-1 -1,4
-2 -2,2
-3 -3
-4 -4