RCA VRC440, Руководство пользователя

Страница: 13 / 48

Chapter 1 11
Connections & Setup
Set the VCR’s CH 3/4 Switch
The CH 3/4 switch on back of the VCR determines what channel the TV must be tuned to see
the VCR’s image. Choose whichever channel is not used locally in your area.
Note: If you connected components using A/V jacks and cables, the VCR’s signal must be
viewed using the TV’s Video Line Input. To find the Video Line Input, refer to the manual
that came with the TV or see
Finding the TV’s Video Line Input on page 40 in the Other
Information section of this manual.
Plug in the VCR
Be sure to insert the plug completely.
Put Batteries in the Remote Control
1. Remove the battery compartment cover on the remote control.
2. Insert new batteries matching the polarities (+ and –) on the batteries with
the diagram in the battery compartment.
3. Put the battery compartment cover back on the remote.
Turn on the TV and VCR
Turn on the TV and press VCR, then POWER, on the remote control to turn on
the VCR.
Note: If you have an RCA, GE, or Proscan TV, your VCR’s remote control
may be able to operate it. Press the TV button on the remote control
and then the POWER button.
Tune the TV
Tune the TV to the VCR viewing channel. The VCR viewing channel is channel
3, 4, or the TV’s video line input.
• If you connect your VCR using RF coaxial cable only, turn the TV to
channel 3 or 4 (whichever was set on the CH 3/4 switch).
• If you connected the VCR using A/V jacks and cables, select the TV’s video
line input. For more information see
Finding the TV’s Video Line Input on
page 40 in the
Other Information
section of this manual.
15763820 (VRC440)(E) 04 S&C 5/25/01, 12:52 PM 11