1. Press and hold the device key for the device you use to change channels. While you’re
holding down this device key, use your other hand to press and hold the remote’s CH up key
at the same time.
2. Wait until the remote’s POWER key comes on and stays on. Then release both keys.
3. Press ENTER to lock channel commands to this device.
To turn channel lock off
:
1. Press and hold the TV key. While you’re holding down the TV key, use your other hand to
press and hold the remote’s CH down key at the same time.
2. Wait until the remote’s POWER key comes on and stays on.
Then release both keys.
3. Press ENTER to start changing channels with your TV.
Code Retrieval
Once you’ve programmed the remote to control your devices, you may want to record the
codes for future reference. If you used the Direct Code Entry method, this is easy. Just find
the codes you entered and make a note of them in the boxes below. If you used one of the
Code Search methods to program your remote or if you used the Direct Entry method but
don’t remember the code, you will need to retrieve each device’s five-digit code. Retrieving
the actual code and writing it down will save you time if you ever need to program the
remote again. If the codes are recorded, you can use the Direct Entry method to reprogram
your remote to control your devices, which is quick and easy.
1. Press and hold the device key (TV, SAT•CBL•DTC, DVD•VCR) whose code you wish to
retrieve. The POWER key illuminates. Keep pressing the device key.
2. While holding the device key down, press and hold the INFO key. The POWER key turns
off. After holding down both keys for three seconds, the POWER key turns back on.
3. Release both keys. The POWER key remains on.
4. Starting with the number 1 key, press and release each number key on the keypad in the
following order: 1-9, then 0. The number that causes the POWER key to blink is the first
number of the code. As you find each number of the code, write it down for future reference.
Note
: All TV codes begin with the number 1; all VCR and DVR codes begin with the
number 2; all DVDs, the number 3; and all satellite receivers, cable boxes and DTV
converters, the number 5.
5. Repeat step 4 until you have retrieved all five numbers in the code. After the fifth number
is retrieved, the POWER key blinks briefly, then turns off.
TIPS
: To exit the Code Retrieval Mode at any time, press the EXIT key.
Note
: If you press an invalid key during the Code
