RCA HSDB2, Руководство по установке

Страница: 3 / 46

2 3
Pencil or
marker
+ connection wires and wire nuts
CONNECT & MOUNT THE POWER KIT
Find the breaker that controls the
circuit for your doorbell. Turn it off
before you continue installation.
Turn off power to your doorbell’s circuit
1
Remove the cover from your doorbell’s chime box
2
Find your doorbell’s chime. Remove
its cover.
IMPORTANT: If your doorbell does not have a chime box, you will need to
install the resistor provided to regulate the power to the doorbell camera.
You can skip this section and follow the instructions in the “If You Don’t
Have A Chime Box” section on page 7.
Connect the power kit connection wires
to the power kit
3
Insert the joined
connector into the
slot on the side of the
power kit.
Remove the existing wires from the chime terminals
4
TRANS FRONT REAR
Loosen the terminal
screws for the doorbell
you want to replace.
Remove the leads from
those terminals.
TRANS FRONT REAR
IMPORTANT: Keep track of which lead goes to which terminal!
Connect the power kit connection wires to the
chime terminals.
5
TRANS FRONT REAR
Remove the sheaths covering the ends
of the solid-wire power kit leads. Bend
the ends of each lead over the terminals
where the old leads were. Then tighten the
terminal screws to hold the leads in place.