10
EN
Playing a Disc - Basic Functions
Unit Operation
Turning the unit on
1. Slide the STANDBY / ON switch on the DVD player to the ON position.
2. The start-up picture will appear on both screens if the DVD player is connected to the
Monitor.
3. After use, slide the STANDBY / ON switch on the DVD player to STANDBY (power off).
Pausing Playback (Still Mode)
Press the PAUSE button. To resume normal
playback, press the PLAY button .
For a DVD, each time you press the PAUSE
button, the picture advances one frame.
Stopping Playback
Press the STOP button at the location where
you want to interrupt playback. To resume
playback at the position where the disc was
stopped, press the PLAY button.
If you press the STOP button twice, the
unit’s memory will be cleared and pressing
the PLAY button will reset the disc to the
beginning.
Fast Forward/Fast Reverse
1. Press the SEARCH
or SEARCH
button when a disc is playing. Each time
the SEARCH
/
button is pressed, the
playback speed changes in the following
sequence:
2. Press the PLAY button when you have
reached the desired point to resume
playback at normal speed.
Notes:
• The DVD player mutes sound and subtitles
during reverse and forward scan of DVDs.
• The fast playback speed may differ
depending on the disc.
This owner’s manual explains the
basic instructions for operating this
unit. Some DVDs are produced in a
manner that allows specific or limited
operation during playback. Therefore,
this unit may not respond to all
operating commands. THIS IS NOT A
DEFECT. Please refer to the instructions
accompanying the specific DVD in
question for more information about
the options available on that DVD.
“ ” may appear on the screen during
operation. A “ ” means that the
desired operation is not permitted by
the unit or disc.
Playing a Disc
1. Slide the STANDBY/ON switch to the ON
position.
See CUSTOMIZING THE DVD FUNCTION
SETTINGS before proceeding to step 2.
2. Press the button and hold the front
panel to open the disc door.
3. Hold the disc by its edge and gently push
it onto the spindle, with the label side
facing the front, until you hear a “click”.
4. Push the disc door gently to close it. It
takes a short while for your unit to load
the disc. After loading, for most DVDs,
the unit will automatically take you main
menu of the DVD or start playing the
DVD.
5. If the unit does not automatically start
playing the DVD, press the PLAY button.
TIP: Press the STOP button once before
turning off the car power or switching off
the unit. This will allow you to resume
DVD playback at the same place the next
time the unit is turned on.
