Installation and Set-up
Fit the rechargeable batteries in each handset
1) Install the AAA batteries (Brand name: CORUN, Capacity: Ni-MH
1.2V/550mAh, or Brand name: SANIK, Capacity: Ni-MH 1.2V/550mAh)
into handset in accordance with the polarity marked in the battery
compartment .
2) Close the battery compartment cover, sliding it into place and pressing
firmly to make sure it is secure.
Connecting AC (electrical) power
Plug the base power adaptor (Type: IA5060, 120Vac/6Vdc/500mA) cord into
the power jack on rear panel of the base and the other end into a 120Vac
50-60Hz electrical outlet .
Before you use the cordless handset for the first time,
it‟s important to
charge the batteries fully.
Leave the handset on the charging cradle for 16 hours.
The battery charge symbol will blink when you're charging an empty
battery.
If you think that the symbol isn't showing the correct battery charge level,
first check that the handset is correctly positioned in the charging cradle.
If y
ou‟re sure that it is, remove and refit the batteries. Please note that it's
normal for the mains adaptor to become warm this doesn't indicate a
fault .
CAUTION: Use only the power supply that came with this unit .
Using other power supplies may damage the unit .
Base adaptor type is IA5060, 120Vac/6Vdc/500mA;
Charge adaptor is IA1560, 120Vac/6Vdc/150mA.
Telephone Operations
Switching on/off
Press and hold the HANG-UP key for more than 2 seconds to switch on/off
the handset in idle mode.
** You can switch the handset off and save battery charge.
Notes: When the handset is OFF, it cannot be used for making
calls including emergency calls. There will be no ringing during
Содержание 2132
Страница 13: ......
