RC Logger NovaX 350, Руководство по эксплуатации

Страница: 47 / 52

Status Indication Table | 47
37. STATUS INDICATION TABLE
Type Status Trigger Front LED Rear LED Buzzer
Flight Mode Basic (ACC assisted) Channel 5 : (+100) Magenta – Solid Refer to chapter ”GPS” None
Altitude (Midstick height hold) Channel 5 : (0)
Green – Solid
Refer to chapter ”GPS” None
GPS (position hold) GPS fixed - No signal
Blue – Blinks (fast)
Refer to chapter ”GPS” None
GPS fixed - Poor signal Blue – Solid Refer to chapter ”GPS” None
Channel 5 : (-100), strong GPS signal Blue – Solid Refer to chapter ”GPS” None
Flight agility
(Bank selection switch)
Channel 6 No indication No indication None
R.T.H. Return-to-Home Channel 5 triggered via switch or Transmitter (Tx) off White – Blinks continuously (0.5 Hz) White – Blinks continuously (0.5 Hz) Beep beep ... pause 1.5 sec. ... beep beep ... ;
Long beep at every step of the process.
Flight Error Low battery level 1 Battery <11.4 V White – Blinks continuously (1 Hz) White – Blinks continuously (1 Hz) Continuous single beeps (1 Hz)
Low battery level 2 Battery <10.5 V White – Blinks continuously (5 Hz) White – Blinks continuously (5 Hz) Continuous single beeps (2 Hz)
Fail safe (PPM failed) Loss of RF signal White – Blinks continuously (0.5 Hz) White – Blinks continuously (0.5 Hz) Beep at each stage of process
Flight Check Error GPS / compass failed Start up main board self test
Red – Blinks continuously (1 Hz) Red – Blinks continuously (1 Hz)
None
Pressure sensor failed
Gyro failed
Power system failed
(ESC/motor)
Permanent system check System error (pilot must land!)
Red – Blinks (fast) Red – Blinks (fast)
Continuous beeps (5 Hz)
Calibration Tx App or button on flight controller
Red – Solid/ Blue – Solid (small LED) Red – Solid
None
Gyro App or button on flight controller
Green – Solid/ Blue – Solid (small LED) Green – Solid
None
Compass App or button on flight controller
Magenta – Solid/ Blue – Solid (small LED) Magenta – Solid
None
Tx Calibration in progress
Red – Solid/ Blue – Blinks (small LED) Red – Solid
Beep at each stage of the process
Gyro Calibration in progress
Green – Solid/ Blue – Blinks (small LED) Green – Solid
Beep at each stage of process
Compass Calibration in progress
Magenta – Solid/ Blue – Blinks (small LED) Magenta – Solid
Beep at each stage of process
Factory state Gyro or compass calibration procedure Invalid gyro or compass calibration
Cyan – Blinks 1Hz (alternating to rear) Cyan – Blinks 1Hz (alternating to rear)
None