RC Logger 88002RC, Руководство по эксплуатации

Страница: 7 / 40

7
> To operate your model, always pull out the telescopic aerial to its full length, because otherwise the
transmitter has a considerably lower range and the transmitter output is subject to more stress than
usual.
> Always switch on the transmitter first. Please ensure that when you turn on the transmitter the throttle
control is set to the lowest setting (motors off)! Then the flight battery of the model may be connected.
Otherwise, unexpected reactions of the model may occur and the rotors might run unintentionally!
> When the rotors are running, make sure that neither objects nor body parts are in the rotating and
suction area of the rotors.
during operation
> Do not take any risks when operating the model. Your own safety and that of your environment depends
completely on your responsible use of the model.
> Improper operation can cause serious damage to people and property! Therefore make sure to keep a
sufficiently safe distance to persons, animals or objects during operation.
> Select suitable ground to operate your model.
> Fly your model only if your ability to respond is unrestricted. The influence of tiredness, alcohol or
medication can cause incorrect responses.
> Do not direct your model towards spectators or towards yourself.
> Motor, flight control system and flight battery may heat up during operation of the model. For this reason,
please take a break of 10 to 15 minutes after flying for a maximum of 20 minutes before recharging the
flight battery or restarting with a possible spare battery. The drive engine must cool down to ambient
temperature.
> Never switch off the remote control (transmitter) while the model is in use. After landing, always disconnect the
flight battery first or switch the model off. Only then may the remote control be switched off.
> In case of a defect or a malfunction, remove the problem before using the model again.
> Never expose your model or the remote control to direct sunlight or excessive heat for an extended
period of time.
> In the case of a severe crash (e.g. from a high altitude). the electric gyro sensors can be damaged and/
or misadjusted.
> Therefore, full functionality must be tested before flying again without fail. We recommend adjustment
to the neutral position.
> In the event of a crash, the throttle should be immediately reduced to zero. Rotating propellers may be
damaged if they come into contact with obstacles e.g. overcharging. Before flying again, these should
be checked for possible tears or breakages!
> To avoid damage to the RC EYE 450 through crashing due to low voltage of the battery through total
discharge, we recommend that you respect the low voltage light signals without fail. As the integrated
LEDs only flash in one direction, we recommend that you additionally fit LiPo Saver order no. 230327.
The Lipo Saver forewarns you of impending low voltage by light signal. Place the Lipo Saver on the
appropriate place of the RC EYE 450.